Search found 15 matches
- 5 years ago
- Forum: Raptor 1000
- Topic: 72-74 degrees ??????????
- Replies: 6
- Views: 4322
Re: 72-74 degrees ??????????
SHE IS FIXED!!!!! Just got back from the best ride I have ever had on my Raptor. Adjusted TPS, Balanced both carbs- they were WAY WAY WWWWWWAAAAAAAAAYYYYYYY Off, Adjusted throttle stop gap, was WAY off Re-adjusted TPS, She now is rideable from idle-throttle on to HOLD ON!! Starts much easier without...
- 5 years ago
- Forum: Raptor 1000
- Topic: 72-74 degrees ??????????
- Replies: 6
- Views: 4322
Re: 72-74 degrees ??????????
It runs fine up to and then past that temp. Its maybe missing a lil but more like there is nothing there at all. Can't tell which cylinder is missing, stopped & idle was all good & free revved just fine. I have just ( coz I could) made a small adjustment to the TPS, hoping that will remove t...
- 5 years ago
- Forum: Raptor 1000
- Topic: 72-74 degrees ??????????
- Replies: 6
- Views: 4322
72-74 degrees ??????????
At about 72 to 74 degrees my 04 X-Tra Rap decides to entirely miss at below 4000rpm, open throttle & she goes, down a couple & she goes. Temp goes above 75 & she is all good But trying to behave in a 60km/h zone to & from work is a bit of a drama. No F1 fault shows, disconnected all ...
- 5 years ago
- Forum: Virtual Bar
- Topic: Hello....Again
- Replies: 1
- Views: 4158
Hello....Again
Been quite a while since I've been here, so I'd better say Hello All.
My beautiful Italian mistress is out of storage & getting those wonderful looks again
My beautiful Italian mistress is out of storage & getting those wonderful looks again
- 7 years ago
- Forum: General Technical
- Topic: Injector Seals?
- Replies: 4
- Views: 2972
Re: Injector Seals?
I have run some really good injector cleaner thru it & removed tank & cleaned it too. As far as my limitied ability can determine the 10-20 micron screen in injector is partially blocked & getting them professionally serviced is the best thing. I found "oem something or other" ...
- 7 years ago
- Forum: General Technical
- Topic: Injector Seals?
- Replies: 4
- Views: 2972
Injector Seals?
Does anyone know where I can get injector seals/o-rings for my 04 Raptor. It is neccesary for me to remove both injectors to get them serviced & would prefer to replace seals with new ones.
Cheers
Cheers
- 7 years ago
- Forum: General Technical
- Topic: rear plug coil ?????
- Replies: 4
- Views: 2531
Re: rear plug coil ?????
swapped over ecm & still the same. Previous owner has replaced fuel pump & not cleaned rust & rubbish & moisture from tank & have figured out there is muck in the lil screen in injector. Ran some pretty serious fuel cleaner through it an its a bit better - will have to put up wit...
- 7 years ago
- Forum: General Technical
- Topic: rear plug coil ?????
- Replies: 4
- Views: 2531
Re: rear plug coil ?????
changed coil & lead from a mates Raptor & its still doing it. Checked & cleaned connector that powers coil. Getting quite confused right now/
- 7 years ago
- Forum: General Technical
- Topic: rear plug coil ?????
- Replies: 4
- Views: 2531
rear plug coil ?????
Loving my raptor in this awesome QLD weather, but having an issue with the rear plug missing. Replaced both plugs with CR8EK ( Cagiva spec ). At idle rear cylinder fires ocassioanally - at 100kph ( 4000rpm) is no dramas, from prolly 3000rpm up she goes like stink :woot: . Tried fiddling with coil pa...
- 7 years ago
- Forum: General Chat
- Topic: MIVV Silencers ??
- Replies: 4
- Views: 3037
Re: MIVV Silencers ??
Fitted MIVV silencers..............removed DB killers................. :evil: :evil: :evil: :evil: DIABOLICAL SOUND!!!!!! I have an EVIL EVIL grin. Guarenteed to scare old people, young kids & any local wildlife. I am nearly speechless - nearly!! Its hard to talk with a massive EVIL GRIN!
- 7 years ago
- Forum: General Technical
- Topic: Open throttle.......0 - 2000rpm wait...wait... SMACK!
- Replies: 2
- Views: 1698
Open throttle.......0 - 2000rpm wait...wait... SMACK!
Just took my 04 Raptor 1000 for its 1st ride & man oh man trying to putt around in traffic & suburbia, had to ride the clutch in 1st gear coz there is a flat spot I could fit both hands & feet in. Open throttle & nothing.....nothing then bang have a handful of rpm. ( Had a brand new ...
- 7 years ago
- Forum: General Chat
- Topic: MIVV Silencers ??
- Replies: 4
- Views: 3037
MIVV Silencers ??
Has anyone fitted MIVV Oval Classic Silencers to a Raptor 1000? I have just bought a kit from Italy, More torque & power would be nice but I am really after that LOUD & DEEP exhaust note with db killers removed. Not fussed at all by those with 'official' pens & pads. Really just want som...
- 7 years ago
- Forum: Virtual Bar
- Topic: Howdy from QLD Australia
- Replies: 12
- Views: 6346
Howdy from QLD Australia
Hello to everyone, thankyou for this forum it is good to know I am not alone owning (1 week till registered) a " so what is it again?" .
04 Raptor 1000 that grew up in Italy till 2011 then moved to Oz & has 34 100k's.
04 Raptor 1000 that grew up in Italy till 2011 then moved to Oz & has 34 100k's.
- 8 years ago
- Forum: General Chat
- Topic: Secondary Air System Hose/Tube
- Replies: 3
- Views: 2439
Re: Secondary Air System Hose/Tube
Thanx Aussiejoe the Cagiva parts list is a big help. Now if only i could find the part i need in real life that would be 'unbeleivable'. The TL1000s is different to the Cagiva. Not real big on blanking it off as I am not too sure exactly what it does (been thru the -Yeh umm, well if I put that 'bit'...
- 8 years ago
- Forum: General Chat
- Topic: Secondary Air System Hose/Tube
- Replies: 3
- Views: 2439
Secondary Air System Hose/Tube
I have just bought a 2004 Raptor 1000. To get it registered in QLD (Australia) I need to replace a few bits. Does anyone know the size of the rubber hose/tube that runs from front exhaust pipe outlet to the 'vac pump'. I am not to keen to pul it off and find out the local parts store doesn't have an...