Raptor Chapter

Hi all im sean (nw uk) ive had my rap about a month ex bike were an rsv also have an ironhead harley. The bike is completely standard but ive just put a jack up kit as its a bit low, and also blanked off the return exhaust emission thing. Hope to chat to you all soon.

Welcome to you from another relatively new member, was it an easy job blanking off the emissions gubbins?

Welcome to the asylum

Hi geoff blanking plates i got off ebay (greasemonkeygarage2014) there 10 pound. Could make them yourself if you have the know how. Its only 2 bolts for each then just remove hose and blank off. The only problem i had were on front cylinder as its exposed to the eliments one nut snapped so i had to drill out the stud, sum how managed to drill perfect and the thread were fine just cleaned up with a tap. Rear cylinder is just a bit fiddley just have get ratchet in on right angle and your fine. Another mod i did intermoto radiator fan switch (red 95-100 degree) m18x 1.5 thread. Only fitted this as temperature were 107 degree other day and i have never seen anything that high before so now fan kicks in earlier and doesn't go over 100 degree.

Thanks Sean, I shall look him up on ebay.