Hi there,
Could anyone recommend a rear paddock stand for a Vrap 650? Would I have to install anything onto my swing arm? Would any generic rear paddock stand do? Many thanks!
Rear paddock stand
- Runs With Scissors
- On the Road
- Posts: 99
- Joined: 21 years ago
- Location: The Colonies
I use an Anderson bike stand, made here in Australia.
Since there is no place on the Raptor to instal bobbins, a la Jappa sportbikes, I use the generic pads that should also come with any new paddock stand.
Another way that I have considered is to make up a rod with the bobbins attached and pass this through the rear axle when I want to use the stand.
I haven't done this yet.... the current 'generic' setup works just fine.
Hope this helps.
Since there is no place on the Raptor to instal bobbins, a la Jappa sportbikes, I use the generic pads that should also come with any new paddock stand.
Another way that I have considered is to make up a rod with the bobbins attached and pass this through the rear axle when I want to use the stand.
I haven't done this yet.... the current 'generic' setup works just fine.
Hope this helps.
If you aren't living on the edge you are taking up too much room.
- Runs With Scissors
- On the Road
- Posts: 99
- Joined: 21 years ago
- Location: The Colonies
- snapdragon
- Moderator
- Posts: 3245
- Joined: 21 years ago
- Location: Wiltshire