Raptor Chapter

My raptor has just done 3200 miles, and when I stop the bike, I get a flashing oil can and the word CHEC on my digital display. The oil warning light isn't on. I've checked the oil and that's OK. Is this message just a reminder that an oil change is due? Can it be re-set somehow by me, or is it something that has to be done by a Cagiva Dealer? Does anyone know?

Thanks

Welcome in Richardbonser

it's the cause you need to get rid of I think - not the flashing can

It isn't an oil change warning that I know of - 2000 miles for that (or thereabouts)
Thats the signal you get when you switch on and you've left the bike in gear - or clicked the kill switch whilst in gear -?.
Or put the sidestand down before you've selected neutral

Might be that the sidestand switch electrics need a clean up and squirt of WD ?

errm - am sure someone else will have other (probly more technical) ideas.

its years since mine had four figures on the display

go to a dealer and let check the sensor of the oil?

snapdragon wrote:Thats the signal you get when you switch on and you've left the bike in gear - or clicked the kill switch whilst in gear -?.
Or put the sidestand down before you've selected neutral

Might be that the sidestand switch electrics need a clean up and squirt of WD ?

errm - am sure someone else will have other (probly more technical) ideas.

i think you're right on it snap good job!

Don't know if you're sorted yet, but I experienced the CHEC message at the weekend. Just replaced my gear change arm. Managed to knock it into gear without realising, I then changed the coolant. When I came to start her again I couldn't work out why it wouldn't start. Hmmmm several minutes of head scratching and a quick consultation of the manual and the penny dropped.

Thought the attached might be helpful



TimO

thanks timo that was very helpful and to the rest of you for taking the time to reply,does anybody no where to get a workshop manual ?all the best to everybody for christmas regards richard

and a merry christmas to you Richard, if you do a search on the site you'll possibly find some chat about workshop manuals, am sure there were a few discussions going on

I find I get the chec message sometimes when I stop after a ride and am revving the bike whilst parking, the counter flashes as if I had just started up the bike with a check oil message. No idea why, sort of got used to it!!!