Raptor Chapter

Hi there everyone,

My name is Dean and i am new member here.

I live in Sweden and a proud owner of a V-Raptor 1000 from 2000.

So bear with me if my questions are somewhat stupid , i am a beginner.

My bike is fitted with race cans from Mivv, K&N air filter and a TRE (Timing Retard Eliminator).

Its clearly going lean, because now and then the engine stops when cold

and at low revs.

So my question is: can i adjust only the CO-screw and find a level by approx. or is necessery to buy a power commander?

The second question: Do anybody know to get hold of a parts list for the raptors?

Best rgds

Dean

are you gaining enough engine heat using the 'choke' (throttle advance start) lever up to about 40 degrees ? that sometimes causes cut out if the engine hasn't been warmed up sufficiently

Welcome to the asylum Dean!

I think I have parts list as pdf somewhere ... I'll have a look- i think its on the other machine xxx

mine runs like a crock o crap until 60.c , stalls aplenty, rough running.
dont go anywhere until the magic number, then ok.

Raptorious wrote:Hi there everyone,

My name is Dean and i am new member here.

I live in Sweden and a proud owner of a V-Raptor 1000 from 2000.

So bear with me if my questions are somewhat stupid , i am a beginner.

My bike is fitted with race cans from Mivv, K&N air filter and a TRE (Timing Retard Eliminator).

Its clearly going lean, because now and then the engine stops when cold

and at low revs.

So my question is: can i adjust only the CO-screw and find a level by approx. or is necessery to buy a power commander?

The second question: Do anybody know to get hold of a parts list for the raptors?

Best rgds

Dean

Hi and welcome.
Trevligt med fler svenskar,
Have you seen this?
http://www.oemmotorparts.com/oem3.asp?M ... %20%201000

Regards,
Magnum