Raptor Chapter

Hi Federico,

welcome, I'll have a Guinness......

Shouldn't be weak at all, I can lock my back wheel a little too easily !!!! As Steve said, check the caliper, make sure the pistons move freely and the rubbers are intact and not allowing crap to ingress around the pistons. Also check that the pads can move freely on the pins, mine were binding slig...

fuel pump is a genuine Suzuki item, had one out at the weekend, but didn't note the reference numbers before replacing, like TLMonkey, i'd say it was the TL1000S unit.

My X-Rap has covered 9,500 miles on the original "Regina" chain and sprokets, still looks fine and within service limits, but have new set to change at 10,000 for peace of mind.

As mentioned, 28mm socket or ring spanner for Nut (should be socket and torque wrench by rights) and a 27mm open-end spanner for securing t'other side... you can get a 28mm individual socket from any decent engineering merchants, tool shop or motor-factor... for info www.beta-tools.com regards Brihass

Hi Den, Stealth were very much alive and kicking about two weeks ago, as they had a stand at Donington Park for the MotoGP. Shall make some calls for you, as I'm sure other's will as well... after thought....depending where Stealth are in Sheffield...Sheffield was subject to some very severe floods ...

45 here....mentally started to regress at 40, or going senile, not too sure which, and don't really care any more !!!!!!!

Hi and welcome...

If your in Glasgow...an English language version will be of no use at all !!!!!!!



regards...

Zane, I picked up my mirrors from Ebay, the Sparco Part No's are: 00001M001, 00001M002, and they came with additional fitting kits for Ducati...I cannot find them on the Sparco Bike website, but may be worth contacting them if interested. They work well, good vision, better than standard, but do tak...

Just put these on mine...





Sparco Mirrors....should be for fairing fitment.. but thought they would look trick as bar ends.....

Hi Ian / Miz,

if Miz can pick up your forks and get them back to Derby, I am around Derby this week and next, if this helps to get them back to yours Ian.

Regards

Bri.

Michelin Pilot Power 2CT's on mine.......so far so good......grip and lean angle awesome....wear rate ok.....wet grip good, but only been caught in a monsoon once....... Several laps around the TT course every morning at 5am last year Crafty... grip was fantastic...just mind the idiots coming the wr...

Hi Gfunk, think you will find this snatchy throttle fuelling problem with anything that uses the Suzuki TL1000 engine, mine was simply on/off at 3000rpm which made town riding quite an art (solution - open roads - balls out !!!!). I fitted a power commander and this smoothed out the fuelling perfect...

Phil,

contact Quill Exhausts (JB Racing) they can put your bike on their dyno and set up the fuelling similar to a yoshi box set-up by changing the mapping electronically. Good set of guys down there... they just fixed Amanda's bike...

www.quillexhausts.com

regards

Bri.

hi, emoto seem to be the best bet for quality carbon copies, you could also try the MV Agusta front guards as they are supposed to fit and are cheaper, although they are shorter at the rear. I have just fitted oval Quill carbon Evo2 cans to my X-Rap, had them made to 380mm and they sound awesome wit...