making progress
making progress
not been around much lately been busy streetfightering the rap and had a right headache with the modified subframe but got there in the end , heres a few pics hope you like whats been done so far.
as you can see ive got R1 forks,calipers and a modified cagiva mito seat unit.
rear sets bolted on to the original frame
billet ali custom top yoke with renthal fat bars
radial master cylinder and hydrolic clutch conversion
and this is the headlight im going to be using once i figure out how im going to fit it and im also going to make a fibreglass shell to make it a one-off.
as you can see ive got R1 forks,calipers and a modified cagiva mito seat unit.
rear sets bolted on to the original frame
billet ali custom top yoke with renthal fat bars
radial master cylinder and hydrolic clutch conversion
and this is the headlight im going to be using once i figure out how im going to fit it and im also going to make a fibreglass shell to make it a one-off.
Re: making progress
Looking good so far mate. Good looking top yoke as well.
To a Raptor....EVERYTHING else is just prey !!
WOOHOO!...TWINS!
WOOHOO!...TWINS!
- Crap Tartan
- On the Road
- Posts: 1545
- Joined: 16 years ago
- Location: Sitting in front of the screen in Portpatrick again
Re: making progress
very nice! (dont think my body could cope with the seat/style etc.!)
what colour you doing the wheels then?
what colour you doing the wheels then?
nil illigitimae carborundum
Re: making progress
havent thought that far ahead yet just want to get it back on the road for next spring
Re: making progress
anyone know anywhere that does pipe bending in the hampshire area ,gotta get the angle of the cans changed I want them swept upwards .
Last edited by craigus 13 years ago, edited 1 time in total.
Re: making progress
its gone a wee bit rusty but a good excuse to get a nice gold one with a stealth sprocket
Re: making progress
craigus wrote:its gone a wee bit rusty but a good excuse to get a nice gold one with a stealth sprocket
Be wary of Stealth sprockets, I ended up sending my last one back and getting a Renthal from B&C Express, the Stealth on was too big on the ID, on the plus side the Renthal was gold to match the chain..
- snapdragon
- Moderator
- Posts: 3245
- Joined: 21 years ago
- Location: Wiltshire
Re: making progress
Not sure of the name just now - but Demonbaker (Ithink) has had pipes done at a place in Wilton (next to Salisbury) is that too far?craigus wrote:anyone know anywhere that does pipe bending in the hampshire area ,gotta get the angle of the cans changed I want them swept upwards .
SnappY
~~X~X~{:>
~~X~X~{:>
Re: making progress
salisbury isnt to far im from southampton area ,I dont think it will be this side of xmas with all this snow about.
- vassilis67
- On the Road
- Posts: 251
- Joined: 14 years ago
- Location: Thessaloniki. Greece
- vassilis67
- On the Road
- Posts: 251
- Joined: 14 years ago
- Location: Thessaloniki. Greece
Re: making progress
By the way, it was 20 celcius when i woke up at 6 o'clock.....
It's all greek to me....